Lexus ES: A25a-fks (fuel)
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / A25a-fks (fuel)
- Fuel Injector (for Direct Injection)
- Fuel Injector (for Port Injection)
- Fuel Main Valve
- Fuel Pressure Sensor
- Fuel Pressure Sensor (for High Pressure)
- Fuel Pump
- Fuel Pump (for High Pressure)
- Fuel Pump Ecu
- Fuel Sender Gauge Assembly
- Fuel System
- Fuel Tank
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FUEL DELIVERY PIPE *2 FUEL INJECTOR SEAL *3 DIRECT FUEL INJECTOR ASSEMBLY *4 SENSOR WIRE *5 NO. 3 FUEL INJECTOR BACK-UP RING *6 O-RING *7
Inspection
INSPECTION PROCEDURE 1. INSPECT DIRECT FUEL INJECTOR ASSEMBLY NOTICE: This inspection is for checking the direct fuel injector assembly for an open or short. Because the direct fuel injector assembly
SEE MORE:
Vehicle Control History
VEHICLE CONTROL HISTORY NOTICE: When checking the Vehicle Control History, make sure to record the output codes. Then, clear the Vehicle Control History (RoB) and check it again. CHECK VEHICLE CONTROL HISTORY (FRONT RADAR SENSOR SYSTEM) (a) Connect the Techstream to the DLC3. (b) Turn the power swit
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 CYLINDER HEAD GASKET (a) Place a new No. 2 cylinder head gasket on the cylinder block sub-assembly as shown in the illustration. *a Lot No. Front of Engine NOTICE:
Remove any oil from the contact surfaces.
Make sure to install the No. 2 cy
© 2016-2026 Copyright www.lexguide.net
