Lexus ES: Fuel Sender Gauge Assembly
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / A25a-fks (fuel) / Fuel Sender Gauge Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY *2 FUEL SENDER GAUGE ASSEMBLY ILLUSTRATION *1 FUEL PUMP GAUGE RETAINER *2 FUEL TANK VENT TUBE ASSEMBLY
Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL SENDER GAUGE ASSEMBLY CAUTION: Perform the inspection in a well-ventilated area. Do not perform the inspection near an open flame. (a) Check that the float moves s
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 FUEL SENDER GAUGE ASSEMBLY (a) Engage the claw to install the No. 2 fuel sender gauge assembly to the fuel tank vent tube assembly. NOTICE: Be careful not to be
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear height control sensor sub-assembly LH removal/installation are shown below. Necessary Procedure Aft
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT DOOR FRONT LOWER FRAME UPPER COVER (a) Engage the 2 guides. (b) Install the front door front lower frame upper cover with the
© 2016-2026 Copyright www.lexguide.net
