Lexus ES: Installation
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Lighting (ext) / Side Turn Signal Light Assembly / Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY
(a) Engage the 4 guides and 2 claws to install the side turn signal light assembly.
2. INSTALL OUTER MIRROR LOWER COVER
Click here .gif)
3. INSTALL OUTER MIRROR COVER ASSEMBLY
Click here
4. INSTALL OUTER MIRROR
Click here
5. PERFORM CALIBRATION (w/ Panoramic View Monitor System)
for HV Model:
Click here
for Gasoline Model:
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY *2 STOP LIGHT SWITCH ASSEMBLY
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the A80 stop light switch assembly connector. *a Front view of wire harness connector (to Stop Li
SEE MORE:
Child safety
Riding with children
Observe the following precautions
when children are in the vehicle.
Use a child restraint system appropriate
for the child, until the child
becomes large enough to properly
wear the vehicle's seat belt.
It is recommended that children
sit in the rear seats to avoid
Components
COMPONENTS ILLUSTRATION *1 BLIND SPOT MONITOR COVER LH *2 BLIND SPOT MONITOR COVER RH *3 BLIND SPOT MONITOR SENSOR LH *4 BLIND SPOT MONITOR SENSOR RH N*m (kgf*cm, ft.*lbf) : Specified torque - -
© 2016-2026 Copyright www.lexguide.net
