Lexus ES: Propeller Shaft Assembly
Lexus ES (XZ10) Service Manual / Drivetrain / Drive Shaft / Propeller Shaft / Propeller Shaft Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT LOWER NO. 1 FLOOR HEAT INSULATOR - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 PROPELLER WITH CENTER BEARING SHAFT ASSE
Inspection
INSPECTION PROCEDURE 1. INSPECT PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (a) Using a dial indicator, measure the runout of the rear propeller shaft assembly (for front side). Maximum Runout: 0
Installation
INSTALLATION PROCEDURE 1. TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (a) When reusing a propeller with center bearing shaft assembly and rear differential carrier assembly: (1
SEE MORE:
Certification ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Certification ECU Communication Stop Mode Any of the following conditions are met:
Communication stop for "Certification (Smart)" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
Communication stop
High Mounted Stop Light Assembly
ComponentsCOMPONENTS ILLUSTRATION *1 CENTER STOP LIGHT SET - - RemovalREMOVAL PROCEDURE 1. REMOVE CENTER STOP LIGHT SET (a) Disengage the 4 guides as shown in the illustration. Disengage in this Direction (b) Turn the center stop light set as shown in the illustration.
© 2016-2026 Copyright www.lexguide.net
