Lexus ES: Power Mirror Control System (for Hv Model With Memory)
Lexus ES (XZ10) Service Manual / Vehicle Interior / Mirror (ext) / Power Mirror Control System (for Hv Model With Memory)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Lost Communication With Body Control Module "B" (U0142)
- Driver Side Power Mirror cannot be Adjusted with Power Mirror Switch
- Front Passenger Side Power Mirror cannot be Adjusted with Power Mirror Switch
- Power Mirror cannot be Adjusted with Power Mirror Switch
- Mirror Heater does not Operate with Rear Defogger Switch
- Power Retractable Mirrors do not Operate with Power Retract Mirror Switch
- AUTO Power Retract Mirrors do not operate
- Power Mirror Surface Position is not Memorized
- Power Mirrors do not Return to Memorized Position
- Reverse Shift-linked Function of Power Mirrors does not Operate
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following s
Parts Location
PARTS LOCATION ILLUSTRATION *1 OUTER REAR VIEW MIRROR ASSEMBLY (DRIVER DOOR) *2 OUTER REAR VIEW MIRROR ASSEMBLY (FRONT PASSENGER DOOR) *3 OUTER MIRROR (DRIVER DOOR) *4 OUTER MIRROR
System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main Body ECU (Multiplex Network Body ECU) Outer Mirror Control ECU Assembly
IG signal
ACC signal
Outer mirror
SEE MORE:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the navigation system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. CUSTOMER PROBLEM ANALYSIS
When troubleshooting, check that the problem symptoms have
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts. Click here PROCEDURE 1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY (a) Install a new gasket to the water
© 2016-2026 Copyright www.lexguide.net
