Lexus ES: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Wiper and Washer System
| DTC No. | Detection Item | DTC Output from | Link |
| B1245 | Lost Communication with Wiper ECU LIN | Main Body | |
| B1279 | Lost Communication with Humidity/Rain Sensor LIN | Main Body | |
| B1370 | ECU Malfunction | Windshield wiper motor assembly | |
| B1372 | Wiper Switch Signal Mismatch between LIN and Line | Wiper | |
| B1373 | Lost Communication with Wiper System LIN BUS | Main Body | |
| B1400 | Rain Sensor Malfunction | Rain sensor | |
READ NEXT:
DESCRIPTION The main body ECU (multiplex network body ECU) and windshield wiper motor assembly communicate via LIN communication. The main body ECU (multiplex network body ECU) stores this DTC if comm
DESCRIPTION The main body ECU (multiplex network body ECU) and rain sensor communicate via LIN communication. The main body ECU (multiplex network body ECU) stores this DTC if communication becomes ab
DESCRIPTION This DTC is stored when the windshield wiper motor assembly detects an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from
SEE MORE:
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear axle hub and bearing assembly on-vehicle inspection are shown below. Necessary Proce
INSPECTION PROCEDURE 1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY (a) Disengage the clamp to disconnect the wire harness protector. *1 Wire Harness Protector (b) Disconnect the engine oil pressure switch assembly connector. (c) Start the engine. (d) Measure the resist
© 2016-2026 Copyright www.lexguide.net
