Lexus ES: P710 (hybrid Transmission / Transaxle)
Lexus ES (XZ10) Service Manual / Drivetrain / P710 (hybrid Transmission / Transaxle)
- Combination Switch
- Hybrid Transaxle Fluid
- Hybrid Transaxle Oil Seal
- Hybrid Transaxle System
- Hybrid Vehicle Transaxle
- Input Shaft Oil Seal
- Motor Cable
- Oil Cooler
- Shift Lever Knob
- Shift Lever Position Sensor
- Shift Lever
- Shift Paddle Switch
- Transmission Control Cable
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) *2 INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Inspection
INSPECTION PROCEDURE 1. INSPECT DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) (a) Inspect the "Normal" mode switch: (1) Measure the resistance according to the value(s) in the table below.
SEE MORE:
Repair
REPAIR CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair.
Ensure that the headlight assembly is not damaged.
Steering Angle Sensor Initialization Incomplete (C1439,C1445)
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) acquires the steering angle sensor zero point every time the power switch on (READY) and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The skid control ECU (brake booster with master cylin
© 2016-2026 Copyright www.lexguide.net
