Lexus ES: Brake System Control Module "A" Calibration / Parameter Memory Failure (C059746)
DESCRIPTION
If the system information stored by the skid control ECU (brake actuator assembly) is corrupted, this DTC is output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C059746 | Brake System Control Module "A" Calibration / Parameter Memory Failure | The skid control ECU (brake actuator assembly) is corrupted or cannot be read. | Skid control ECU (brake actuator assembly) |
| Vehicle Condition | |||
|---|---|---|---|
| Pattern 1 | Pattern 2 | ||
| Diagnosis Condition | - | - | - |
| Malfunction Status | The skid control ECU (brake actuator assembly) is corrupted. | ○ | - |
| The skid control ECU (brake actuator assembly) is cannot be read. | - | ○ | |
| Detection Time | - | - | |
| Number of Trips | 1 trip | 1 trip | |
HINT:
DTC will be output when conditions for either of the patterns in the table above are met.
CAUTION / NOTICE / HINT
NOTICE:
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
Click here .gif)
PROCEDURE
| 1. | REPLACE BRAKE ACTUATOR ASSEMBLY |
(a) Replace the skid control ECU (brake actuator assembly).
Click here
| NEXT |  | END |
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Electronically Controlled Brake System DTC No. Detection Item Link C00631C Yaw Rate Sensor Circuit Voltage Out of Range C00631F Yaw Rate Sensor Ci
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Electronically Controlled Brake System DTC No. Detection Item Link C00631C Yaw Rate Sensor Circuit Voltage Out of Range C00631F Yaw Rate Sensor Ci
SEE MORE:
Open in Outer Mirror Indicator(Slave) (C1AB5)
DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects an open in the outer rear view mirror indicator LH. DTC No. Detection Item DTC Detection Condition Trouble Area C1AB5 Open in Outer Mirror Indicator(Slave) Both of the following conditions are met:
The b
Hood
Opening the hood
1. Pull the hood lock release lever.
The hood will pop up slightly.
2. Pull up the auxiliary catch lever and
lift the hood.
WARNING
■Pre-driving check
Check that the hood is fully closed and
locked.
If the hood is not locked properly, it may
open while the vehicl
