Lexus ES: Installation

Lexus ES (XZ10) Service Manual / Vehicle Exterior / Lighting (ext) / Headlight Ecu / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

1. INSTALL HEADLIGHT GASKET

(a) Install a new headlight gasket.

2. INSTALL HEADLIGHT ECU SUB-ASSEMBLY

NOTICE:

If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.

(a) for Single Beam Headlight:

(1) Connect the connector.

(b) for Triple Beam Headlight:

(1) Connect the 2 connectors.

(d) Install the headlight ECU sub-assembly with the 3 screws.

3. INSTALL HEADLIGHT ASSEMBLY

for LED Type Turn Signal Light:

Click here

for Bulb Type Turn Signal Light:

Click here

SEE MORE:

Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly removal/installation are shown below. Necessary Procedure

Components

COMPONENTS ILLUSTRATION *1 ENGINE WIRE *2 NO. 1 VACUUM HOSE CONNECTOR *3 VACUUM PUMP ASSEMBLY *4 NO. 1 VACUUM PUMP O-RING Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) ● Non-reusable par

Lexus ES: Installation

READ NEXT:

Height Control Sensor

Components

Components

SEE MORE:

Removal

Components