Lexus ES: Components
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Lighting (ext) / Height Control Sensor / Components
COMPONENTS
ILLUSTRATION
| *1 | REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for 2WD *B for AWD *1 REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH - - N*m (kgf*cm, ft.*lbf): Specified torque - -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for 2WD) (a) Preparation for check (1) Confirm the standard, high and low positions of the link that will be used in the fol
SEE MORE:
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WIPER RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage not applied between terminals 1
Blind Spot Monitor Beam Axis Inspection Incomplete (C1AF9)
DESCRIPTION This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating that the beam axis inspection is incomplete. DTC No. Detection Item DTC Detection Condition Trouble Area C1AF9 Blind Spot Monito
© 2016-2026 Copyright www.lexguide.net
