Lexus ES: Components
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Lighting (ext) / Height Control Sensor / Components
COMPONENTS
ILLUSTRATION
| *A | for 2WD | *B | for AWD |
| *1 | REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for 2WD) (a) Preparation for check (1) Confirm the standard, high and low positions of the link that will be used in the fol
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH NOTICE: If the rear height control sensor sub-assembly LH has been struck or dropped, replace it with a new one. (a) for 2W
SEE MORE:
Blind Spot Monitor Master Module (C1AB6)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area C1AB6 Blind Spot Monitor Master Module The blind spot monitor sensor RH (master) detects an internal malfunction Blind
Engine Coolant Temperature Sensor 1 Signal Stuck in Range (P01152A)
DESCRIPTION Refer to DTC P011511. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P01152A Engine Coolant Temperature Sensor 1 Signal Stuck in Range Either of the following conditions is met (2 trip detection logic):
When engine is st
© 2016-2026 Copyright www.lexguide.net
