Lexus ES: Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here .gif)
PROCEDURE
1. INSTALL SPARK PLUG
HINT:
Perform "Inspection After Repair" after replacing a spark plug.
Click here
(a) Install the 4 spark plugs to the cylinder head sub-assembly.
Torque:
20 N·m {204 kgf·cm, 15 ft·lbf}
NOTICE:
If a spark plug has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
2. INSTALL IGNITION COIL ASSEMBLY
Click here
3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Click here
4. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.
Click here
READ NEXT:
Air Conditioning Filter
Components
COMPONENTS
ILLUSTRATION
*1
AIR FILTER COVER PLATE
*2
CLEAN AIR FILTER
*3
LOWER INSTRUMENT COVER
*4
Components
COMPONENTS
ILLUSTRATION
*1
NO. 1 HV BATTERY INTAKE FILTER
*2
BATTERY SERVICE HOLE COVER
SEE MORE:
Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
rear brake flexible hose removal/installation are shown below.
Necessary Procedures After Parts
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MOTOR COVER (a) Disconnect the connector. (b) Disengage the 2 clamps. (c) Disengage the 4 claws to remove the motor cover as shown in the illustration. Remove in this Direction 2. REMOVE SWING GRILLE ACTUATOR ASSEMBLY (a) Remove the swing gril
