Lexus ES: Inspection
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / Hybrid / Battery Control / Fuse Box / Inspection
INSPECTION
PROCEDURE
1. INSPECT HYBRID BATTERY TERMINAL BLOCK
| (a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the hybrid battery terminal block. |
|
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL HYBRID BATTERY TERMINAL BLOCK CAUTION: Be sure to wear insulated gloves and protective goggles. (a) Connect the 2 hybrid battery terminal block connectors. NOTICE: Ma
Components
COMPONENTS ILLUSTRATION *1 BATTERY SERVICE HOLE COVER *2 SERVICE PLUG GRIP ILLUSTRATION *1 CONNECTOR COVER ASSEMBLY *2 ENGINE ROOM MAIN WIRE Tightening torque for "Major
SEE MORE:
Components
COMPONENTS ILLUSTRATION *A w/ Power Trunk Lid System - - *1 LUGGAGE COMPARTMENT DOOR ASSIST GRIP *2 LUGGAGE COMPARTMENT DOOR COVER *3 LUGGAGE LOCK CONTROL CABLE PLATE *4 SWITCH BEZEL ILLUSTRATION *1 LUGGAGE COMPARTMENT DOOR HINGE COVER LH *2 LUGGAGE COMPART
Inspection
INSPECTION PROCEDURE 1. INSPECT DIRECT FUEL INJECTOR ASSEMBLY NOTICE: This inspection is for checking the direct fuel injector assembly for an open or short. Because the direct fuel injector assembly of this vehicle is a high-pressure type, fuel injection volume cannot be checked. (a) Measure the
© 2016-2026 Copyright www.lexguide.net
