Lexus ES: Fuse Box
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 NO. 1 HV BATTERY SHIELD PANEL *2 UPPER HV BATTERY COVER SUB-ASSEMBLY *3 HYBRID BATTERY TERMINAL BLOCK - - N*m (kgf*cm, ft.*lbf): Specified torque
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hybr
Inspection
INSPECTION PROCEDURE 1. INSPECT HYBRID BATTERY TERMINAL BLOCK (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Speci
SEE MORE:
Checking and replacing fuses
If any of the electrical components
do not operate, a fuse may have
blown. If this happens, check and
replace the fuses as necessary.
Checking and replacing fuses
1. Turn the power switch off.
2. Open the Fuse box cover.
Engine compartment: type A fuse
box
Push the tab in and lift the lid
Test Mode Procedure
TEST MODE PROCEDURE TEST MODE (SIGNAL CHECK MODE) PROCEDURE HINT:
When entering test mode (signal check mode), the tire pressure warning ECU and receiver sets all the test mode (signal check mode) DTCs first.
After the tire pressure warning ECU and receiver completes the signal check for each ins
© 2016-2026 Copyright www.lexguide.net
