Lexus ES: Heated Steering Wheel System (for Hv Model)
Lexus ES (XZ10) Service Manual / Steering / Steering Column / Heated Steering Wheel System (for Hv Model)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Lost Communication with Steering Heater ECU (B14B7)
- Steering Wheel does not Heat Up When Heated Steering Wheel Switch is Pressed
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following s
Parts Location
PARTS LOCATION ILLUSTRATION *1 SPIRAL CABLE SUB-ASSEMBLY *2 STEERING WHEEL HEATER SWITCH (REFRESHING SEAT SWITCH) *3 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - ECU-IG1 NO. 3 FUSE *4
System Diagram
SYSTEM DIAGRAM SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Radio Receiver Assembly Air Conditioning Amplifier Assembly
Steering wheel heater switch operation co
SEE MORE:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING (INNER RACE) (a) Using SST and a press, install a new front differential case front tapered roller bearing (inner race) to the differential case assembly. SST: 09316-20011 SST: 09513-36040 NOTICE:
Do not dam
Installation
INSTALLATION PROCEDURE 1. INSTALL DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) (a) Install the drive mode select switch (combination switch assembly) to the instrument cluster finish panel assembly with the 3 screws. (b) Engage the clamp to connect the wire harness to the instrument cluste
© 2016-2026 Copyright www.lexguide.net
