Lexus ES: Dtc Check / Clear
Lexus ES (XZ10) Service Manual / Steering / Steering Column / Heated Steering Wheel System (for Hv Model) / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.
Body Electrical > Air Conditioner > Trouble Codes(e) Check for DTCs.
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.
Body Electrical > Air Conditioner > Clear DTCs(e) Clear DTCs.
READ NEXT:
Fail-safe Chart
FAIL-SAFE CHART DIAGNOSIS FUNCTION
Heated steering wheel controller (steering vibration ECU) has diagnosis function. Condition Detection Condition Response when malfunction detected Recove
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HEATED STEERING WHEEL SYSTEM DTC No. Detection Item Link B14B7 Lost Communication with Steering Heater ECU
SEE MORE:
Test Mode Procedure
TEST MODE PROCEDURE TEST MODE PROCEDURE NOTICE: After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode. HINT:
When entering test mode, th
Installation
INSTALLATION PROCEDURE 1. INSTALL TELEPHONE ANTENNA ASSEMBLY (for Moon Roof) (a) When reusing the telephone antenna assembly: (1) Install a new seal. (b) Push the telephone antenna assembly in the direction indicated by the arrow (1) shown in the illustration to engage the guide. Install in t
© 2016-2026 Copyright www.lexguide.net
