Lexus ES: Heated Steering Wheel System (for Gasoline Model)
Lexus ES (XZ10) Service Manual / Steering / Steering Column / Heated Steering Wheel System (for Gasoline Model)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Lost Communication with Steering Heater ECU (B14B7)
- Steering Wheel does not Heat Up When Heated Steering Wheel Switch is Pressed
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the c
Parts Location
PARTS LOCATION ILLUSTRATION *1 SPIRAL CABLE SUB-ASSEMBLY *2 STEERING WHEEL HEATER SWITCH (REFRESHING SEAT SWITCH) *3 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - ECU-IG1 NO. 3 FUSE *4
System Diagram
SYSTEM DIAGRAM SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Radio Receiver Assembly Air Conditioning Amplifier Assembly
Steering wheel heater switch operation co
SEE MORE:
Steering Position Sensor (B2414)
DESCRIPTION The headlight ECU sub-assembly LH receives steering angle signals from the steering sensor via CAN communication and performs light control. for LED Type Turn Signal Light DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from B2414 Steering Position
Inspection
INSPECTION PROCEDURE 1. INSPECT KNOCK CONTROL SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 25°C (77°F) 120 to 280 kΩ If the result is not as specified, replace the k
© 2016-2026 Copyright www.lexguide.net
