Lexus ES: Heated Steering Wheel Controller
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 HEATED STEERING WHEEL CONTROLLER (STEERING VIBRATION ECU) *2 STEERING WHEEL PAD BRACKET
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heat
Installation
INSTALLATION PROCEDURE 1. INSTALL HEATED STEERING WHEEL CONTROLLER (STEERING VIBRATION ECU) (a) Connect the connector to the heated steering wheel controller (steering vibration ECU). (b) Install t
SEE MORE:
Before Starting Adjustment
BEFORE STARTING ADJUSTMENT CAUTION / NOTICE / HINT NOTICE: When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Lexus genuine part. If a non-Lexus genuine part is used, the forward recognition camera may not be able to be installed due to a
Inspection
INSPECTION PROCEDURE 1. INSPECT AIR FUEL RATIO SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 (HA1B) - 2 (+B) 20°C (68°F) 2 to 6 Ω 1 (HA1B) - 4 (A1B-) Always 10 kΩ o
© 2016-2026 Copyright www.lexguide.net
