Lexus ES: Voice is not Recognized
PROCEDURE
(a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation.
OK:
Voice command is recognized normally.
HINT:
-
When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon.
-
If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
-
The system cannot recognize voice commands when multiple people are speaking simultaneously.
-
If the speaking speed is too fast or too slow, the recognition rate may decrease.
-
The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).
| OK | | END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SPEECH CONDITION) |
READ NEXT:
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below. Necessary Procedures After P
DIAGNOSTIC TROUBLE CODE CHART LIN Communication System DTC No. Detection Item Link B1206 P/W Master Switch Communication Stop B1273 Sliding Roof ECU Communication Stop B2321 D-Door Motor ECU Communication Stop B2322 P-Door Motor ECU Communication Stop
© 2016-2026 Copyright www.lexguide.net
