Lexus ES: Fuel Injector (for Port Injection)
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / A25a-fxs (fuel) / Fuel Injector (for Port Injection)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for EGR Valve Bracket Connection Type *B for Cylinder Head Cover Sub-assembly Connection Type *1 FUEL DELIVERY PIPE SUB-ASSEMBLY *2 NO. 1 FUEL PIPE SUB-A
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during port
Inspection
INSPECTION PROCEDURE 1. INSPECT PORT FUEL INJECTOR ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connec
SEE MORE:
A/F (O2) Sensor Signal Biased/Stuck Lean Bank 1 Sensor 2 Circuit Current Above Threshold (P227019,P227118)
DESCRIPTION Refer to DTC P003612. Click here HINT: Although the DTC title say O2 sensor, these DTCs relate to the air fuel ratio sensor (sensor 2). DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P227019 A/F (O2) Sensor Signal Biased/Stuck Lean Bank
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RADIO SETTING CONDENSER (a) With the radio setting condenser installed, check that there is no looseness or other abnormalities. (b) Measure the resistance of the radio setting condenser according to the value(s) in the table below. Standard Resistance:
© 2016-2026 Copyright www.lexguide.net
