Lexus ES: Starter
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FLYWHEEL HOUSING SIDE COVER *2 STARTER ASSEMBLY *3 NO. 2 ENGINE WIRE - - Tightening torque for "Major areas involving basic vehicle performance su
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY (a) Remove the 2 bolts. (b) While lifting the rear of the magnet starter switch assembly disconnect it from terminal C.
Inspection
INSPECTION PROCEDURE 1. INSPECT STARTER ASSEMBLY CAUTION: As a large electric current passes through the cable during this inspection, a thick cable must be used. If not, the cable may become hot and
SEE MORE:
Parts Location
PARTS LOCATION ILLUSTRATION *1 TRUNK AND FUEL SWITCH ASSEMBLY *2 LUGGAGE DOOR OPENING CANCEL SWITCH ASSEMBLY *3 DLC3 *4 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *5 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - DOOR BACK RELAY - TRUNK OPN FUSE *6 CERTIFICATION ECU (SMART
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during black out tape removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/
© 2016-2026 Copyright www.lexguide.net
