Lexus ES: Sliding Roof Housing (for Panoramic Moon Roof)
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Sliding Roof / Convertible / Sliding Roof Housing (for Panoramic Moon Roof)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Front Side *B for Rear Side *1 FRONT SLIDING ROOF GARNISH LH *2 FRONT SLIDING ROOF GARNISH RH *3 SLIDING ROOF GLASS SUB-ASSEMBLY *4 SLIDING
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during slid
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY (a) Disengage the 3 claws and 2 pins. (b) Move the roof wind deflector panel sub-assembly in the direction indicated by the arro
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
Do not apply excessive force to the forward recognition camera connector.
CHECK FORWARD RECOGNITI
Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL LID OPENER SWITCH (TRUNK AND FUEL SWITCH ASSEMBLY) (a) Check the switch. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 2 (B) - 3 (L) Pressed (On) Be
© 2016-2026 Copyright www.lexguide.net
