Lexus ES: Repair
REPAIR
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
- If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair.
- Ensure that the headlight assembly is not damaged.
PROCEDURE
1. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER (for TMC Made)
| (a) Cut off the part shaded in the illustration and sand smooth with sandpaper. HINT: After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer. |
|
| (b) Install the upper headlight protector retainer with the 2 screws. |
|
2. INSTALL LOWER HEADLIGHT PROTECTOR RETAINER (for TMC Made)
| (a) Cut off the part shaded in the illustration and sand smooth with sandpaper. HINT: After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer. |
|
| (b) Install the lower headlight protector retainer with the 2 screws. |
|
3. INSTALL LOWER NO. 2 HEADLIGHT PROTECTOR RETAINER (for TMC Made)
| (a) Cut off the part shaded in the illustration and sand smooth with sandpaper. HINT: After cutting off the part, place the lower No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer. |
|
| (b) Install the lower No. 2 headlight protector retainer with the 2 screws. |
|
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 LOWER STEERING COLUMN COVER SUB-ASSEMBLY *2 TURN SIGNAL SWITCH *3 UPPER STEERING COLUMN COVER - -
Removal
REMOVAL PROCEDURE 1. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column) Click here 2. REMOVE LOWER STEERING COLUMN COVER S
SEE MORE:
Generator Temperature Sensor Circuit Short to Ground (P0A3611,P0A3615)
DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs are stored when the generator temperature sensor output is abnormal. The cause of this malfunction may be one of the following: Hybrid vehicle control ECU malfunction
Hybrid vehicle control ECU internal malfunction
Generator temperature sensor ma
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL HOOD SUPPORT BRACKET (a) Engage the guide. (b) Install the hood support bracket with the bolt. Torque: 17.5 N·m {178 kgf·cm, 13 f
