Lexus ES manuals

Lexus ES: Repair

Lexus ES (XZ10) Service Manual / Vehicle Exterior / Lighting (ext) / Headlight Assembly (for Bulb Type Turn Signal Light) / Repair

REPAIR

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.
  • If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair.
  • Ensure that the headlight assembly is not damaged.

PROCEDURE

1. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER (for TMC Made)

Click here

2. INSTALL LOWER HEADLIGHT PROTECTOR RETAINER (for TMC Made)

Click here

3. INSTALL LOWER NO. 2 HEADLIGHT PROTECTOR RETAINER (for TMC Made)

Click here

READ NEXT:

 Headlight Assembly (for Led Type Turn Signal Light)

 Components

COMPONENTS ILLUSTRATION *1 COWL TOP PANEL INSULATOR *2 FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY *3 HEADLIGHT ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - I

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during head

SEE MORE:

 Components

COMPONENTS ILLUSTRATION *1 COWL TOP PANEL INSULATOR *2 FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY *3 HEADLIGHT ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *A for TMC Made - - *1 FRONT SIDE MARKER LIGHT BULB *2 FRONT TURN SI

 Components

COMPONENTS ILLUSTRATION *1 NO. 2 RADIATOR HOSE *2 WATER INLET WITH THERMOSTAT SUB-ASSEMBLY *3 GASKET *4 NO. 7 WATER BY-PASS HOSE N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part

© 2016-2026 Copyright www.lexguide.net