Lexus ES: Problem Symptoms Table
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Mirror (ext) / Power Mirror Control System (for Hv Model Without Memory) / Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
If the auxiliary battery voltage is low, the mirror heater function may not operate.
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
| Symptom | Suspected Area | Link |
|---|---|---|
| Electrical remote control mirror does not operate | Outer mirror switch assembly | |
| Outer rear view mirror assembly LH | | |
| Outer rear view mirror assembly RH | | |
| Wire harness or connector | - | |
| Mirror heater does not operate | Proceed to "Mirror Heater does not Operate with Rear Defogger Switch" | |
| Automatic glare-resistant EC mirror does not operate | Inner rear view mirror assembly | |
| Outer rear view mirror assembly LH | | |
| Outer rear view mirror assembly RH | | |
| Wire harness or connector | - |
.gif)
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST ACTIVE TEST HINT: Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive func
Mirror Heater does not Operate with Rear Defogger Switch
DESCRIPTION When the mirror heater switch (rear window defogger switch) on the air conditioning control assembly is pressed, the operation signal is sent to the air conditioning amplifier assembly via
SEE MORE:
Data Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) (a)
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE END COVER (a) Using a T30 "TORX" socket wrench, remove the 5 screws and end cover. NOTICE:
Hold the pump so that the pump installation surface, fitting parts and oil pipe will not be damaged.
As the housing deforms when force is applied, do not secure the ho
© 2016-2026 Copyright www.lexguide.net
