Lexus ES manuals

Lexus ES: Precaution

Lexus ES (XZ10) Service Manual / Power Source & Network / A25a-fks (battery / Charging) / Charging System / Precaution

PRECAUTION

INITIALIZATION

NOTICE:

Make sure to perform the necessary procedures (adjustment, calibration, initialization, or registration) after parts related to the cable has been disconnected from the negative (-) battery terminal.

Click here

CHARGING SYSTEM PRECAUTION

NOTICE:

  • Check that the battery cables are connected to the correct terminals.
  • Disconnect the battery cables when the battery is given a quick charge.
  • Do not perform tests with a high voltage insulation resistance tester.
  • Never disconnect the battery cables while the engine is running.
  • Check that the charging cable nuts are tightened on terminal B of the generator assembly and on the No. 1 engine room relay block and No. 1 junction block assembly.

READ NEXT:

 Battery

ComponentsCOMPONENTS ILLUSTRATION *1 BATTERY *2 NEGATIVE BATTERY TERMINAL *3 POSITIVE BATTERY TERMINAL *4 NO. 2 BATTERY CLAMP *5 BATTERY TERMINAL CAP *6 BATTERY INSULATO

 Steering

h1 {color:red;} h2 {color:blue;} h3 {color:green;}

 Power Assist Systems

SEE MORE:

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below. Necessary Procedure After Parts Removed

 Fuel Pump Control General Electrical Failure (P12D501)

DESCRIPTION Refer to DTC P062712. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P12D501 Fuel Pump Control General Electrical Failure When the fuel pump control ECU operation duty ratio is 3 to 65%, the fuel pump control ECU detects a

© 2016-2026 Copyright www.lexguide.net