Lexus ES manuals

Lexus ES: Precaution

Lexus ES (XZ10) Service Manual / Engine & Hybrid System / Hybrid / Battery Control / Electric Vehicle Converter / Precaution

PRECAUTION

PRECAUTION WHEN REMOVING/INSTALLING INVERTER WITH CONVERTER ASSEMBLY

CAUTION:

  • Be careful not to injure yourself on the edges of the inverter with converter assembly when performing work.
  • Do not push down or apply excessive force to the inverter with converter assembly.

NOTICE:

Observe the following in order to prevent entry of foreign matter:

  • Do not allow foreign matter such as grease, oil or water to adhere to the inside of the inverter with converter assembly.
  • Do not use air tools in areas other than specified to prevent entry of dust.
  • Prevent wind from blowing through the workshop to prevent entry of dust.
  • Do not drop any bolts or tools into the inverter with converter assembly.
  • Clean the tools before use.

NOTICE:

PRECAUTION WHEN HANDLING ELECTRONIC COMPONENTS

  • Do not touch the terminals of the connectors or areas other than the specified on circuit boards, as static electricity may be applied to parts and damage them.
  • Do not drop electronic components such as circuit boards or subject them to impact.
  • Keep the removed parts free from dust.
  • Electronic components are very sensitive. Be sure to observe the handling instructions.

NOTICE:

PRECAUTION WHEN HANDLING PARTS

  • Do not drop parts or subject them to impact.
  • If a part is subject to impact, replace it with a new one.
  • Be sure to observe the handling instructions to prevent parts from being damaged.

NOTICE:

PRECAUTION WHEN SUSPENDING WORK

  • If suspending work, cover parts with clean pieces of paper to prevent entry of dust and foreign matter.

HINT:

  • Arrange the removed parts in the correct order so that they can be installed to the correct position and with the correct orientation.
  • It is recommended to take pictures of parts before removing them to ensure correct installation.

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 WIRE HARNESS CLAMP BRACKET *2 INVERTER WITH CONVERTER ASSEMBLY *3 NO. 1 INVERTER BRACKET *4 NO. 2 INVERTER BRACKET *5 INVERTER PROTECTOR - -

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during HV c

 Installation

INSTALLATION CAUTION / NOTICE / HINT NOTICE: Do not cross-thread the bolts when installing them. PROCEDURE 1. HOW TO PREVENT STATIC ELECTRICITY SST: 09890-47010 NOTICE: Static electricity should be

SEE MORE:

 Left Rear Wheel Speed Sensor Internal Electronic Failure (C050C49)

DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC is stored. DTC No. Detection Item DTC Detection Condition Trouble Area C050C49 Left R

 Installation

INSTALLATION CAUTION / NOTICE / HINT NOTICE: This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts. Click here PROCEDURE 1. INSTALL ENGINE OIL LEVEL SENSOR (a) Using an 8 mm socket wrench, install the engine oi

© 2016-2026 Copyright www.lexguide.net