Lexus ES: Park / Neutral Position Switch
Lexus ES (XZ10) Service Manual / Drivetrain / Ub80f (automatic Transmission / Transaxle) / Park / Neutral Position Switch
READ NEXT:
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT NOTICE: Before adjusting the park/neutral position switch assembly, check that the shift lever is in N. PROCEDURE 1. SECURE VEHICLE (a) Fully apply the parking brake
Components
COMPONENTS ILLUSTRATION *1 BATTERY CLAMP SUB-ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 TRANSMISSION CONTROL CABLE ASSEMBLY *2 TRANSMISS
Inspection
INSPECTION PROCEDURE 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below when the transmission control shaft lever is moved to e
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front brake removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Re
Height Sensor Initialization Incomplete (B2450)
DESCRIPTION The headlight ECU sub-assembly LH stores this DTC if initialization has not been performed after it was replaced. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from B2450 Height Sensor Initialization Incomplete
The power switch is on (IG).
© 2016-2026 Copyright www.lexguide.net
