Lexus ES: Oil Pump
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 CLUTCH DRUM OIL SEAL RING *2 FRONT OIL PUMP BODY *3 FRONT OIL PUMP DRIVE GEAR *4 FRONT OIL PUMP DRIVEN GEAR *5 OIL STRAINER ASSEMBLY *6 RING PI
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE CLUTCH DRUM OIL SEAL RING (a) Remove the 4 clutch drum oil seal rings from the stator shaft assembly. NOTICE: Do not expand the gap of the clutch drum oil seal rings
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT OIL PUMP ASSEMBLY (a) Install the oil pump drive shaft sub-assembly to the front oil pump assembly. NOTICE:
To avoid damaging the bush of the front oil pump as
SEE MORE:
Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF SUSPENSION TOWER DAMPER (a) Using a hacksaw, make a hole in the cylinder between (A) and (B) shown in the illustration to discharge the gas inside. *a 10 mm CAUTION:
Always use a cloth to prevent shards of metal from flying about due to the release of pre
Installation
INSTALLATION PROCEDURE 1. INSTALL RAIN SENSOR TAPE HINT: The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated with foreign matter. (a) Clean the sensing portion of the rain sensor with a piece of cloth. (b) Peel off the smaller release sheet, and then attach the r
© 2016-2026 Copyright www.lexguide.net
