Lexus ES: Lost Communication with Brake System Control Module (U0129)
DESCRIPTION
The tire pressure warning ECU and receiver receives signals from the skid control ECU (brake actuator assembly) via CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
| U0129 | Lost Communication with Brake System Control Module | Lost communication with skid control ECU (brake actuator assembly) | -
CAN communication system
-
Skid control ECU (Brake actuator assembly)
| - |
PROCEDURE
| 1. | GO TO CAN COMMUNICATION SYSTEM |
(a) Go to CAN communication system.
Click here
| NEXT | | END |
READ NEXT:
DESCRIPTION If the tire pressure warning ECU and receiver detects any problems, the tire pressure warning light blinks for 1 minute then illuminates, and tire pressure monitoring is disabled at the sa
DESCRIPTION The tire pressure warning ECU and receiver identifies the tire position for each tire pressure warning valve and transmitter according to the wheel speed signals from the skid control ECU
DESCRIPTION When "Change Wheel Set" is selected on the multi-information display and the "OK" switch (steering pad switch assembly) is pushed and held, the system enters ID registration mode and the t
SEE MORE:
DESCRIPTION The skid control ECU (brake actuator assembly) determines the steering angle value based on data obtained from the steering sensor, yaw rate and acceleration sensor (airbag ECU assembly). DTC No. Detection Item DTC Detection Condition Trouble Area C05262A Steering Angle Se
INSTALLATION PROCEDURE 1. INSTALL BLIND SPOT MONITOR BUZZER (a) Connect the connector. (b) Engage the clamp to install the blind spot monitor buzzer. 2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade) Click here 3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade) Click here
© 2016-2026 Copyright www.lexguide.net
