Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL BLIND SPOT MONITOR BUZZER
(a) Connect the connector.
(b) Engage the clamp to install the blind spot monitor buzzer.
2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)
Click here .gif)
3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)
Click here
4. INSTALL REAR SEAT SHOULDER BELT COVER
Click here
5. INSTALL CENTER STOP LIGHT SET (w/o Rear Sunshade)
Click here
6. CONNECT REAR SEAT OUTER BELT ASSEMBLY LH
Click here
7. CONNECT REAR SEAT OUTER BELT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
8. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
Click here
9. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
10. INSTALL REAR SEAT SIDE GARNISH LH
Click here
11. INSTALL REAR SEAT SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
12. INSTALL REAR DOOR SCUFF PLATE LH (for HV Model)
Click here
13. INSTALL REAR DOOR SCUFF PLATE LH (for Gasoline Model)
Click here
14. INSTALL REAR DOOR SCUFF PLATE RH (for HV Model)
HINT:
Use the same procedure as for the LH side.
15. INSTALL REAR DOOR SCUFF PLATE RH (for Gasoline Model)
HINT:
Use the same procedure as for the LH side.
16. INSTALL REAR SEAT ASSEMBLY
Click here
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during bli
Television Camera (for Front)
ComponentsCOMPONENTS ILLUSTRATION *1 COOL AIR INTAKE DUCT SEAL *2 FRONT TELEVISION CAMERA ASSEMBLY InstallationINSTALLATION PROCEDURE 1. INSTALL FRONT TELEVISION CAMERA ASSEMBLY (a) Eng
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK FOR DTCS (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Hybrid Control / Trouble Codes. Powertrain > Hybrid Control > Trouble Codes (e) Check the DTCs and freeze frame da
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Back Door / Trouble Codes. Body Electrical > Back Door > Trouble Codes (e) Check for DTCs. Click here CLEAR DTC (
