Lexus ES: Cannot Switch to Automatic ID Registration Mode
Lexus ES (XZ10) Service Manual / Suspension / Tire Pressure Monitoring / Tire Pressure Warning System(for Gasoline Model) / Cannot Switch to Automatic ID Registration Mode
DESCRIPTION
When "Change Wheel Set" is selected on the multi-information display and the "OK" switch (steering pad switch assembly) is pushed and held, the system enters ID registration mode and the tire pressure warning light blinks 3 times.
The main body ECU (multiplex network body ECU) receives signals from the combination meter assembly via the CAN communication line.
WIRING DIAGRAM
PROCEDURE
| 1. | CHECK TEST MODE (TIRE PRESSURE WARNING RESET SWITCH CHECK [DTC C2198]) |
(a) Perform Test Mode Procedure (Tire Pressure Warning Reset Switch Check (DTC C2198)).
Click here 
| NEXT |  | GO TO DTC C2198 |
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 TIRE PRESSURE WARNING VALVE AND TRANSMITTER *2 TUBELESS TIRE VALVE *3 DISC WHEEL *4 VALVE CORE *5 TIRE VALVE CAP *6 TIRE *7 TIRE PRESSURE
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tire
SEE MORE:
Camshaft Position Sensor "A" Bank 1 or Single Sensor No Signal (P034031)
DESCRIPTION Refer to DTC P034011. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P034031 Camshaft Position Sensor "A" Bank 1 or Single Sensor No Signal No camshaft position sensor (for intake camshaft) signal for 5 seconds at an engine
Drive Motor "A" Performance (P0A9000)
DTC SUMMARY MALFUNCTION DESCRIPTION This DTC indicates that magnetic force deterioration of the permanent magnet located in the rotor inside the motor (MG2) has been detected. The cause of this malfunction may be one of the following: Area Main Malfunction Description Inverter Inverter wi
© 2016-2026 Copyright www.lexguide.net
