Lexus ES: Installation
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / A25a-fks (lubrication) / Oil Pump / Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here .gif)
PROCEDURE
1. INSTALL ENGINE BALANCER ASSEMBLY
Click here
2. INSTALL STIFFENING CRANKCASE ASSEMBLY
Click here
3. INSTALL OIL PUMP ASSEMBLY
(a) Install the oil pump assembly to the stiffening crankcase assembly with the 3 bolts.
Torque:
24 N·m {245 kgf·cm, 18 ft·lbf}
4. INSTALL OIL PUMP BRACKET
Click here
5. INSTALL ENGINE OIL LEVEL SENSOR
Click here
6. INSTALL OIL STRAINER SUB-ASSEMBLY
Click here
7. INSTALL NO. 2 OIL PAN SUB-ASSEMBLY
Click here
8. INSTALL TIMING CHAIN COVER ASSEMBLY
Click here
READ NEXT:
Engine Switch
InspectionINSPECTION PROCEDURE 1. INSPECT ENGINE SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connectio
Relay
InspectionINSPECTION PROCEDURE 1. INSPECT ST RELAY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection C
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts. Click here PROCEDURE 1. INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR (a) Type A: (1) Install the No. 3 exhaus
Route cannot be Calculated
PROCEDURE 1. SET DESTINATION (a) Set another destination and check if the system can calculate the route correctly. OK: Route can be correctly calculated. OK END NG PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
© 2016-2026 Copyright www.lexguide.net
