Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL VACUUM SWITCHING VALVE (for Active Control Engine Mount System)
(a) Install the vacuum switching valve (for active control engine mount system) to the front engine mounting insulator with the nut.
Torque:
6.0 N·m {61 kgf·cm, 53 in·lbf}
(b) Connect the 3 vacuum hoses to the vacuum switching valve (for active control engine mount system).
(c) Engage the wire harness clamp and connect the vacuum switching valve (for active control engine mount system) connector.
(d) Install the 2 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
(e) Engage the wire harness clamp and install the engine wire with the bolt.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
2. INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
Click here .gif)
3. INSTALL INLET AIR CLEANER ASSEMBLY
Click here
4. INSTALL COOL AIR INTAKE DUCT SEAL
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 VENTILATION HOSE *2 PURGE VALVE (PURGE VSV) *3 NO. 1 FUEL VAPOR FEED HOSE *4 NO. 2 SURGE TANK STAY *5 INTAKE AIR SURGE TANK ASSEMBLY *6 AIR SUR
SEE MORE:
Multi-axis Acceleration Sensor Module "A" Component Internal Failure (C052096)
DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via CAN communication. These DTCs may be stored if on
Replacement
REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear axle hub bolt removal/installation are shown below. Necessary Procedures After Parts Removed/I
