Lexus ES: Camshaft
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 VENTILATION HOSE *2 PURGE VALVE (PURGE VSV) *3 NO. 1 FUEL VAPOR FEED HOSE *4 NO. 2 SURGE TANK STAY *5 INTAKE AIR SURGE TANK ASSEMBLY *6 AIR SUR
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during cams
Installation
INSTALLATION PROCEDURE 1. SET NO. 1 CYLINDER TO TDC (COMPRESSION) (a) Confirm that the timing mark (cutout) on the crankshaft pulley is aligned with the "0" timing mark of the timing chain cover as
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT HV BATTERY JUNCTION BLOCK ASSEMBLY (a) Inspect SMRB: (1) Measure the resistance according to the value(s) in the table below. *a Component without harness connected (HV Battery Junction Block Assembly) - - Standard Resistance: Tester Connection Cond
Generator Control Module Position Sensor REF Power Source Circuit Voltage Out of Range (P06B01C,...,P313487)
DESCRIPTION The motor generator control ECU (MG ECU), which is built into the inverter with converter assembly, monitors its internal operation and will store DTCs if it detects a malfunction. If any of the following DTCs are output, replace the inverter with converter assembly. DTC No. Detecti
© 2016-2026 Copyright www.lexguide.net
