Lexus ES manuals

Lexus ES: Installation

Lexus ES (XZ10) Service Manual / Drivetrain / Axle And Differential / Steering Knuckle / Installation

INSTALLATION

CAUTION / NOTICE / HINT

for HV Model:

  • When removing or installing the front disc brake caliper assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C1214 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this procedure.
  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL STEERING KNUCKLE

(a) Secure the steering knuckle between aluminum plates in a vise.

NOTICE:

Do not overtighten the vise.

(b) Install the front axle hub sub-assembly and front disc brake dust cover to the steering knuckle with the 4 bolts.

Torque:

120 N·m {1224 kgf·cm, 89 ft·lbf}

NOTICE:

  • Be careful not to damage the speed sensor rotor or contact surfaces.
  • Do not allow foreign matter to contact the speed sensor rotor or contact surfaces.

2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY

Click here

3. INSTALL FRONT AXLE ASSEMBLY

Click here

READ NEXT:

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ste

 Drive Shaft / Propeller Shaft

 Drive Shaft System

PrecautionPRECAUTION NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSEMBLY RH (for AWD) (a) When removing and installing the front drive shaft assembly RH in an AWD vehicle, be sure to first d

SEE MORE:

 Hydraulic Test

HYDRAULIC TEST PERFORM HYDRAULIC TEST CAUTION: Do not perform a stall test if there are any people or objects near the vehicle. The vehicle could begin moving suddenly, resulting in a serious accident. Do not perform a stall test if any wheel chocks are out of position. The vehicle co

 Inspection

INSPECTION PROCEDURE 1. INSPECT REAR LIGHT ASSEMBLY LH *a Component without harness connected (Rear Light Assembly LH) (a) Apply auxiliary battery voltage to the rear light assembly LH and check that the lights illuminate. OK: Measurement Condition Specified Condition Auxiliary ba

© 2016-2026 Copyright www.lexguide.net