Lexus ES: Axle And Differential
Lexus ES (XZ10) Service Manual / Drivetrain / Axle And Differential
- Axle System
- Differential Mount Cushion
- Differential Oil
- Differential System
- Front Axle Hub Bolt
- Front Axle Hub
- Rear Axle Carrier (for 2wd)
- Rear Axle Carrier (for Awd)
- Rear Axle Hub (for 2wd)
- Rear Axle Hub (for Awd)
- Rear Axle Hub Bolt
- Rear Differential Carrier Assembly
- Rear Differential Carrier Oil Seal
- Rear Differential Side Gear Shaft Oil Seal
- Steering Knuckle
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of pr
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of pr
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL LUGGAGE DOOR OPENING SWITCH (TRUNK AND FUEL SWITCH ASSEMBLY) (a) Engage the 2 claws to install the luggage door opening switch (trunk and fuel switch assembly) as shown in the illustration. Install in this Direction 2. INSTALL LOWER INSTRUMENT PANEL FINISH
Brake Switch "B" Circuit Short to Battery (P070312)
DESCRIPTION The purpose of the stop light switch signal circuit is to prevent the engine from stalling when the brakes are suddenly applied while driving in the lock-up condition. When the brake pedal is depressed, the stop light switch assembly sends a signal to the ECM. The ECM then cancels the op
© 2016-2026 Copyright www.lexguide.net
