Lexus ES: Initialization
INITIALIZATION
RESET BACK-UP BATTERY CONDITION
HINT:
If the back-up battery (mobilephone battery) has been replaced, it is necessary to perform the Reset Backup Battery Condition procedure.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Choose "Telematics" from the System Selection Menu, and then click "Utility".
(e) Click "Backup Battery Replacement Reset" on the Utility Selection Menu.
Body Electrical > Telematics > Utility| Tester Display |
|---|
| Backup Battery Replacement Reset |
(f) According to the display on the Techstream, perform Backup Battery Replacement Reset to reset the mobilephone battery replacement flag.
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - DCM FUSE - ECU-IG2 NO. 3 FUSE *2 DLC3 *3 AIRBAG ECU ASSEMBLY *4 DCM (TELEMATICS TRANSCEIVER) - MOBILEPHONE
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the ter
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during forward recognition camera removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced (for
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT CAUTION: If the rear disc brake cylinder assembly has been disassembled, perform air bleeding for the rear disc brake cylinder assembly. for Gasoline Model: Click here for HV Model: Click here NOTICE:
Make sure not to scratch, damage or apply excessive forc
© 2016-2026 Copyright www.lexguide.net
