Lexus ES: Hv Battery Thermistor
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / Hybrid / Battery Control / Hv Battery Thermistor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 UPPER HV BATTERY COVER SUB-ASSEMBLY *2 HV BATTERY JUNCTION BLOCK ASSEMBLY *3 ELECTRIC VEHICLE BATTERY PLUG ASSEMBLY *4 WIRING HARNESS PROTECTOR N*
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hybr
Installation
INSTALLATION PROCEDURE 1. INSTALL HYBRID BATTERY THERMISTOR CAUTION: Be sure to wear insulated gloves and protective goggles. (a) Engage the 3 claws of the hybrid battery thermistor (sensor portion
SEE MORE:
HO2S Heater Control Circuit Bank 1 Sensor 2 Circuit Short to Battery (P003612,P003614,P005612,P005614,P014118,P016118,P102A9E,P105A9E)
DESCRIPTION Refer to DTC P013611. Click here HINT:
When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the engine switch is turned off.
The heated oxygen sensor heater circuit use
Terminals Of Ecu
TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the J20 multiplex network master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector discon
© 2016-2026 Copyright www.lexguide.net
