Lexus ES: Fuel Vapor Containment Valve
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / A25a-fxs (emission Control) / Fuel Vapor Containment Valve
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FUEL VAPOR CONTAINMENT VALVE (FUEL TANK SOLENOID MAIN VALVE ASSEMBLY) *2 FUEL TANK VENT HOSE SUB-ASSEMBLY *3 FUEL TANK VENT HOSE - - N*m (kgf*cm,
Removal
REMOVAL PROCEDURE 1. REMOVE FUEL VAPOR CONTAINMENT VALVE (FUEL TANK SOLENOID MAIN VALVE ASSEMBLY) (a) Disconnect the fuel vapor containment valve (fuel tank solenoid main valve assembly) connector.
Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL VAPOR CONTAINMENT VALVE (FUEL TANK SOLENOID MAIN VALVE ASSEMBLY) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
SEE MORE:
Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis inspection is performed. Completing the beam axis
Generator Position Sensor Circuit "A" Circuit Open (P0C6413,P0C641F,P0C6913,P0C691F)
DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate that the resolver output signal is abnormal. The cause of this malfunction may be one of the following: Area Main Malfunction Description Inverter low-voltage circuit The connectors are not connected properly Hybrid Vehicle Trans
© 2016-2026 Copyright www.lexguide.net
