Lexus ES: Inspection
INSPECTION
PROCEDURE
1. INSPECT FUEL VAPOR CONTAINMENT VALVE (FUEL TANK SOLENOID MAIN VALVE ASSEMBLY)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 25 to 30 Ω |
If the result is not as specified, replace the fuel vapor containment valve (fuel tank solenoid main valve assembly).
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL VAPOR CONTAINMENT VALVE (FUEL TANK SOLENOID MAIN VALVE ASSEMBLY) (a) Install the fuel vapor containment valve (fuel tank solenoid main valve assembly) to the veh
Components
COMPONENTS ILLUSTRATION *1 PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY) - -
SEE MORE:
Hybrid/EV Battery Cooling Fan 1 Circuit Short to Ground (P0A8111)
DESCRIPTION The battery cooling blower assembly speed is controlled by the battery ECU assembly. Power is supplied to the battery cooling blower assembly when the MREL terminal of the hybrid vehicle control ECU turns on the IGCT relay. The battery ECU assembly sends command signals (SI0) to the batt
Installation
INSTALLATION PROCEDURE 1. INSTALL EGR COOLER ASSEMBLY (a) Install a new EGR cooler gasket to the EGR cooler assembly. NOTICE: Make sure that the claws of the EGR cooler gasket are toward the EGR cooler assembly side. *a Claw (b) Install a new EGR valve gasket to the EGR
© 2016-2026 Copyright www.lexguide.net
