Lexus ES: CAN Communication Failure (Message Registry) (U1000)
Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Parking Support Alert System (for Gasoline Model) / CAN Communication Failure (Message Registry) (U1000)
DESCRIPTION
If DTC U1000 is stored frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again even if the DTC is not output when rechecking for DTCs.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U1000 | CAN Communication Failure (Message Registry) | ECU malfunction | Clearance warning ECU assembly |
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Clear the DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs(b) Check for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble CodesOK:
DTC U1000 is not output.
HINT:
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even if the DTC was not output when rechecking for DTCs.
Click here .gif)
| OK |  | USE SIMULATION METHOD TO CHECK |
| NG | | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
READ NEXT:
Buzzer does not Sound
WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Inspect the fuses for circuits related to this system before per
Front Left Sensor Malfunction (C1AE1)
DESCRIPTION The front corner ultrasonic sensor LH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultrasonic sens
SEE MORE:
Power Mirror Surface Position is not Memorized
DESCRIPTION If any of the M1, M2 or M3 seat memory switch is pressed, the outer mirror control ECU assembly (driver door) detects the switch operation and sends the seat memory switch signal to the main body ECU (multiplex network body ECU) via CAN communication. On receiving the seat memory switch
Installation
INSTALLATION PROCEDURE 1. INSTALL DCM (TELEMATICS TRANSCEIVER) 2. INSTALL NO. 1 TELEPHONE BRACKET (a) Install the No. 1 telephone bracket with the screw. 3. INSTALL TELEPHONE BRACKET (a) Install the telephone bracket with the screw. 4. INSTALL DCM (TELEMATICS TRANSCEIVER) WITH BRACKET (a) Connect ea
© 2016-2026 Copyright www.lexguide.net
