Lexus ES manuals

Lexus ES: Front Camera Internal Circuit (C2A60)

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Panoramic View Monitor System (for Gasoline Model) / Front Camera Internal Circuit (C2A60)

DESCRIPTION

This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the front television camera assembly via CAN communication.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C2A60

Front Camera Internal Circuit

A signal indicating a malfunction in the front television camera assembly is detected.

Front television camera assembly

CAUTION / NOTICE / HINT

NOTICE:

  • When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

PROCEDURE

1.

CHECK FOR DTC

(a) Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs

(b) Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes

OK:

DTC C2A60 is not output.

OK

END
NG

REPLACE FRONT TELEVISION CAMERA ASSEMBLY

READ NEXT:

 Side Camera LH Internal Circuit (C2A61)

DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly LH via CAN communication. DTC No. Detection Item DTC

 Side Camera RH Internal Circuit (C2A62)

DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly RH via CAN communication. DTC No. Detection Item DTC

 Back Camera Internal Circuit (C2A63)

DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the rear television camera assembly via CAN communication. DTC No. Detection Item DTC Det

SEE MORE:

 Parts Location

PARTS LOCATION ILLUSTRATION *1 OUTER REAR VIEW MIRROR ASSEMBLY RH *2 OUTER REAR VIEW MIRROR ASSEMBLY LH *3 BRAKE ACTUATOR ASSEMBLY - SKID CONTROL ECU *4 ECM *5 OUTER MIRROR CONTROL ECU ASSEMBLY RH *6 OUTER MIRROR CONTROL ECU ASSEMBLY LH *7 OUTER REAR VIEW MIRROR I

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated steering wheel controller (steering vibration ECU) removal/installation are shown below. Necessar

© 2016-2026 Copyright www.lexguide.net