Lexus ES manuals

Lexus ES: Back Camera Internal Circuit (C2A63)

DESCRIPTION

This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the rear television camera assembly via CAN communication.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C2A63

Back Camera Internal Circuit

A signal indicating a malfunction in the rear television camera assembly is detected.

Rear television camera assembly

CAUTION / NOTICE / HINT

NOTICE:

  • When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

PROCEDURE

1.

CHECK FOR DTC

(a) Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs

(b) Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes

OK:

DTC C2A63 is not output.

OK

END

NG

REPLACE REAR TELEVISION CAMERA ASSEMBLY

READ NEXT:

 Wheel Speed Sensor Malfunction (C164D)

DESCRIPTION This DTC is stored when the parking assist ECU receives a wheel speed sensor (front speed sensor RH or front speed sensor LH, rear speed sensor RH or rear speed sensor LH) abnormality s

 Vehicle Information Unmatched (C168D)

DESCRIPTION This DTC is stored if the parking assist ECU judges as a result of its self check that the vehicle information received via CAN communication and the vehicle information stored in the p

 ECU Malfunction (C1611)

DESCRIPTION This DTC is stored if the rear television camera assembly judges that there is an internal malfunction as a result of its self check. HINT: The rear television camera assembly stores diffe

SEE MORE:

 Reassembly

REASSEMBLY CAUTION / NOTICE / HINT NOTICE: Steps 10 to 17 are temporary reassembly procedures for adjustment purposes. PROCEDURE 1. INSTALL STRAIGHT PIN (a) Using a plastic-faced hammer, install the 4 straight pins to the rear differential carrier sub-assembly. *a 8.0 to 9.0 mm (0.315 to 0.354

 For safe driving

For safe driving, adjust the seat and mirror to an appropriate position before driving. Correct driving posture Adjust the angle of the seatback so that you are sitting straight up and so that you do not have to lean forward to steer. Adjust the seat so that you can depress the pe

© 2016-2025 Copyright www.lexguide.net