Lexus ES: Egr Valve
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for EGR Valve Bracket Connection Type - - *1 NO. 1 EGR PIPE SUB-ASSEMBLY *2 EGR VALVE ASSEMBLY *3 EGR VALVE BRACKET *4 EGR INLET GASKET *5
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR
Inspection
INSPECTION PROCEDURE 1. INSPECT EGR VALVE ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condit
SEE MORE:
Removal
REMOVAL PROCEDURE 1. PRECAUTION (for HV Model) NOTICE:
When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
A communication malfunc
Installation
INSTALLATION PROCEDURE 1. INSTALL VACUUM SWITCHING VALVE (for Active Control Engine Mount System) (a) Install the vacuum switching valve (for active control engine mount system) to the front engine mounting insulator with the nut. Torque: 6.0 N·m {61 kgf·cm, 53 in·lbf} (b) Connect the 3 vacuum h
© 2016-2026 Copyright www.lexguide.net
