Lexus ES: Lost Communication with Panoramic View Monitor Control Module (U023B)
DESCRIPTION
These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly.
HINT:
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
| U023B | Lost Communication with Panoramic View Monitor Control Module | Lost Communication with Television Camera Controller | CAN communication system |
PROCEDURE
(a) Clear the DTCs.
Chassis > Parking Assist Camera > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Chassis > Parking Assist Camera > Trouble Codes
HINT:
-
If CAN communication system DTCs are stored, they may also be stored in other systems.
-
If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
-
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even if the DTC was not output when rechecking for DTCs.
Click here
| Result | Proceed to |
| DTCs are output | A |
| No DTCs are output | B |
| A | | GO TO CAN COMMUNICATION SYSTEM |
| B | | USE SIMULATION METHOD TO CHECK |
READ NEXT:
DESCRIPTION These DTCs are stored if there is a malfunction in the CAN communication system connected to the parking assist ECU. HINT: If CAN communication system DTCs are stored, they may also be sto
DESCRIPTION These DTCs are stored when communication between the parking assist ECU and front television camera assembly, side television camera assembly LH, side television camera RH is not possible.
DESCRIPTION If DTC U1000 is stored frequently, duplicate the problem symptoms and perform troubleshooting again even if the DTC is not output when rechecking for DTCs. DTC No. Detection Item DT
SEE MORE:
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
When replacing the radio receiver assembly, always re
DESCRIPTION This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating a malfunction in the blind spot monitor sensor. DTC No. Detection Item DTC Detection Condition Trouble Area C1AF7 RCTB Sensor
© 2016-2026 Copyright www.lexguide.net
