Lexus ES: Diagnosis System
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Exterior Panels / Trim / Grille Shutter System / Diagnosis System
DIAGNOSIS SYSTEM
DESCRIPTION
(a) Grille shutter system data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.
CHECK DLC3
(a) Check the DLC3.
Click here .gif)
INSPECT AUXILIARY BATTERY VOLTAGE
(a) Measure the auxiliary battery voltage with the power switch off.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery.
READ NEXT:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / (desired system) / T
Data List / Active Test
DATA LIST / ACTIVE TEST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-int
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Grille Shutter System DTC No. Detection Item Link B1333 Shutter Control State Maintenance Mode P059F73 Active Grille Air Shutter "A" Actuator Stuc
SEE MORE:
Power Source Circuit
DESCRIPTION This circuit provides power to operate the blind spot monitor sensor. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following procedure. PROCEDURE 1. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts. Click here PROCEDURE 1. INSTALL VACUUM HOSE (a) Install the vacuum hose to the intake manifold. 2. INSTALL NO.
© 2016-2026 Copyright www.lexguide.net
