Lexus ES manuals

Lexus ES: Dtc Check / Clear

Lexus ES (XZ10) Service Manual / Vehicle Exterior / Exterior Panels / Trim / Grille Shutter System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.

Body Electrical > Grille Shutter > Trouble Codes Powertrain > Engine > Trouble Codes

(e) Check the details of the DTC(s).

Click here

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.

Body Electrical > Grille Shutter > Clear DTCs Powertrain > Engine > Clear DTCs

(e) Clear the DTCs.

READ NEXT:

 Data List / Active Test

DATA LIST / ACTIVE TEST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-int

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Grille Shutter System DTC No. Detection Item Link B1333 Shutter Control State Maintenance Mode P059F73 Active Grille Air Shutter "A" Actuator Stuc

 Shutter Control State Maintenance Mode (B1333)

DESCRIPTION This DTC is stored when the grille shutter system is changed to maintenance mode. DTC No. Detection Item DTC Detection Condition Trouble Area B1333 Shutter Control State Mai

SEE MORE:

 Left Rear Wheel Speed Sensor Circuit Short to Battery (C050C12)

DESCRIPTION Each speed sensor detects wheel speed and sends signals to the skid control ECU (brake actuator assembly). These signals are used by the ABS control. The speed sensor detects the magnetic fields of the speed sensor rotor as it rotates and outputs a pulse signal. The frequency of the puls

 Quarter Garnish

ComponentsCOMPONENTS ILLUSTRATION *1 REAR ROOF DRIP SIDE FINISH MOULDING - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING (a)

© 2016-2025 Copyright www.lexguide.net