Lexus ES: Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Lane Control / Data List.
(e) According to the display on the Techstream, read the Data List.
Chassis > Lane Control > Data List| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Total Distance Traveled | - | - | - | Cannot be used |
| Total Distance Traveled - Unit | - | - | - | Cannot be used |
| LDA Control | Lane control system control status | Prohibit or Permit | Prohibit: Control prohibited Permit: Control permitted | - |
| Turn Switch (Right) | Right turn signal switch status | OFF or ON | ON: Right turn signal switch on OFF: Right turn signal switch off | - |
| Turn Switch (Left) | Left turn signal switch status | OFF or ON | ON: Left turn signal switch on OFF: Left turn signal switch off | - |
| Vehicle Information (2WD/4WD) | - | - | - | Cannot be used |
| Vehicle Information (Conv/HV) | - | - | - | Cannot be used |
ACTIVE TEST
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Lane Control / Active Test.
(e) According to the display on the Techstream, perform the Active Test.
Chassis > Lane Control > Active Test| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Meter Buzzer | Sounds the meter buzzer | Start or Stop | Perform this Active Test with the vehicle is stopped and power switch on (IG). |
READ NEXT:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Lane Control System DTC No. Detection Item Link C1A7496 Steering Vibrator Component Internal Failure U012587 Lost Communication with Multi-axis Ac
Vehicle Control History
VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again. CHECK VEHICLE CONTROL HISTORY (LANE CO
Steering Vibrator Component Internal Failure (C1A7496)
DESCRIPTION If the forward recognition camera receives a steering vibration ECU malfunction signal, DTC C1A7496 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area C1A7
SEE MORE:
Calibration
CALIBRATION TORQUE SENSOR ZERO POINT CALIBRATION (USING TECHSTREAM) NOTICE: Perform torque sensor zero point calibration if any of the following conditions occur:
The rack and pinion power steering gear assembly has been replaced.
There is a difference in steering effort between turning left an
Hybrid/EV Battery Positive and Negative Contactor Actuator Stuck Closed (P0AA073)
DTC SUMMARY MALFUNCTION DESCRIPTION The hybrid vehicle control ECU detects a stuck closed malfunction of a system main relay on the positive (+) terminal side and negative (-) terminal side of the HV battery. The cause of this malfunction may be one of the following: Inverter voltage sensor (VH) in
