Lexus ES: Steering Vibrator Component Internal Failure (C1A7496)
DESCRIPTION
If the forward recognition camera receives a steering vibration ECU malfunction signal, DTC C1A7496 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A7496 | Steering Vibrator Component Internal Failure | While the lane control system is on, a malfunction signal from the steering vibration ECU is detected by the forward recognition camera for 5 seconds or more. | Steering vibration ECU |
CAUTION / NOTICE / HINT
NOTICE:
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.
Click here .gif)
PROCEDURE
| 1. | REPLACE STEERING VIBRATION ECU |
(a) Replace the steering vibration ECU.
Click here
| NEXT | .gif) | END |
READ NEXT:
Lost Communication with Multi-axis Acceleration Sensor Module Missing Message (U012587,U012687,U012987,U013187,U015587,U029387)
DESCRIPTION When a communication malfunction is detected between the forward recognition camera and an ECU or sensor, a DTC is stored. DTC No. Detection Item DTC Detection Condition Trouble A
Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message (U023587)
DESCRIPTION The forward recognition camera and millimeter wave radar sensor assembly communicate via CAN communication. If there is an error in the communication with the millimeter wave radar sensor
Internal Control Module Software Incompatibility Not Programmed (U030051)
DESCRIPTION The forward recognition camera receives the vehicle information from the hybrid vehicle control ECU via CAN communication. If the forward recognition camera cannot store the vehicle inform
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during HV battery junction block assembly removal/installation are shown below. Necessary Procedures After Part
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT DOOR FRONT LOWER FRAME UPPER COVER (a) Engage the 2 guides. (b) Install the front door front lower frame upper cover with the
